Harig Grind All #2 Large Capacity V-Block Spin Fixture Used

Description

You are looking at a used, original, Harig Grind All #2 Large Capacity V-Block Spin Fixture.  This unit also serves as a rotary table, it has the optional rotary table mechanism attached to it for horizontal use as well.  As you can see, it has a small crank handle that you can put on the unit. For spin fixture use, it is best to take this optional mechanism out and it is removed with two screws.  I have never tested the accuracy of this item on a machine.  I did put an indicator on the locator bore inside the face plate on the front of the unit and it has approximately .007 runout.  I also put an indicator on the face plate that is on the rotary table towards the outer of the edge and it has approximately .0003 face runout.  It looks to be at one time the small rotary table mechanism was repaired, it looks like a new shaft was put in it as well and seal was put in the unit.  It seems to work fine, it has an approximate .015 endplay on the small little shaft, the rotary table mechanism still works.    This unit also is able to index and has a stop pin that is spring loaded that you can also lock open to do spin grinding.  It has a crank handle on the back of it.  I do not see any engraving on the unit at all.  According to the tag on this unit the center height of this unit is approximately 4.00 inches.  The face plate has tapped holes in it so you can mount fixtures and so forth.  I am also including only the tooling that goes with it as shown in the photos, it has a couple clamps and a v-block that mounts and slides on it.  The two V-block clamps have some wear on them, they also look like they were modified,  and the one clamp the ears are bent, however it is still usable.  Also included is a small round additional face plate that mounts on the face plate of the grinding fixture, it will need cleaned and stoned off. This  plate allows you to mount various fixtures.  I am also including the 2 magnetic chucks shown as a bonus.  The larger magnetic chuck on the back of it says it is a Magnetool Tool. These magnetic chucks bolt to the supplementary face plate. These magnetic chucks are manually operated with a removable round bar that goes in the side to turn them on  and off. I have not checked the accuracy of the the chucks, mounting plate or V-block.  This also includes the original wood box that it came in.  Some of the storage box has wear on the inside, and is not perfect, but still usable.  Also included is the stops that go on the back side of the face plate.  The stops do work.  These units are very expensive  new.  Also, please note that this is a manually operated unit, it is not motorized, it does not accept collets.  This is U.S.A. made.  Be sure to ask any questions before purchasing.  This item will be sold as-is, no returns or refunds once this item is purchased.
This will be shipped UPS Ground only with Signature Confirmation to ensure its delivery.  I ship to the U.S.A only.
Please note that I ship Monday through Friday only, not Saturday or Sunday. If your payment is received on a Friday it will be shipped the following Monday.